Loading ...
to inspect the mold parting line fit of core and cavity as well as slidersto preventflash issue of injection molding
an annular seal around commutator ring 308 near tangs 318preventsflash during molding
strong resultsis being createdout of injection molding
mold is closedto preventflash during molding
Outer layer grooves ... the cantileverwas createdin injection molding
shapecausedin injection molding
This value ... the cantileverwas createdin injection molding
impact strength and film properties such as sliding property , plating property , adhesiveness and further ... aptto causeflash at the time of injection molding
the non - Newtonian behavior ... too smallto effectively preventan occurrence of molding flash upon injection molding
arms and legscreatedout of injection molding
a large amount of styrene infused airborne residue that is not a particularly good thing , as you can well imaginecreatesa large amount of styrene infused airborne residue that is not a particularly good thing , as you can well imagine
Deformation prevention(passive) caused byDeformation prevention
LED ModuleledLED Module
darkening short luminous efficiency ( luminous ZnSmay causedarkening short luminous efficiency ( luminous ZnS
composition into an articleresultingcomposition into an article
in pellets per shotcan be setin pellets per shot
the tireto createthe tire
what Specdrums needed in the short - term as well as the ability to scale as the company continued to growcreateswhat Specdrums needed in the short - term as well as the ability to scale as the company continued to grow
in yield decline and so onresultingin yield decline and so on